IDAC
Technical Support:
11
2.2.2
BACKLIGHT
The Indoor Module allows the brightness of its LED to be managed according to two
operating modes: normal and night mode.
Please refer to the specific manual “
Brightness
” (available in the IDAC product section
at the Zennio website,
) for detailed information about the functionality
and the configuration of the related parameters.
2.2.3
ROOM STATE BUTTONS
The buttons of the Indoor Module are intended to control the state of the room (
normal,
do not disturb
and
make-up request
).
Two types of control are available:
Do Not Disturb:
a single button that switches between
Normal
and
Do Not
Disturb
.
➢
If the current state of the room is
Normal
or
Make-Up Request
and the
button is pressed, it is activated
Do Not Disturb.
➢
If the current state of the room is
Do Not Disturb
and the button is pressed,
it is activated
Normal.
Double:
two buttons of which the right switches between
Do Not Disturb
and
Normal
and the left between
Make-Up Request
and
Normal.
Note
:
Please, note that the type of control must be selected according to the product
design.
ETS PARAMETERIZATION
When the function
Room State Buttons
in “Configuration” tab, in Indoor Module, a
new tab will be available in the left tree. In addition, three objects will appear and will
allow to monitor and control the state of the room:
“[Access] Room State Indicator”
and
“[Access] Room State”, “[Access] Room State: Make Up Room (Status)”
and
“[Access] Room State: Do Not Disturb (Status)”.
Please refer to the
“Access Control”
user manual, available under the IDAC product
, for detailed information.
