CONNECTION PANEL
REAR
ANTENNA INPUT CONNECTOR
Connect the VHF/UHF/CATV antenna to this terminal.
AUDIO OUT JACK:
Connect this output jack to the audio input on an external unit (Audio
System, TV/Monitor, Another VCR).
VIDEO OUT JACK:
Connect this output jack to the video input on an external device
(TV/Monitor, Another VCR).
AUDIO IN JACK:
Connect the audio output cable from an external device (Audio
system, TV/Monitor, Another VCR) to this jack.
VIDEO IN JACK:
Connect the video output cable from an external device (TV/Monitor,
Another VCR) to this jack.
Use
INPUT
to select A/V input channels (LINE1 or LINE2).
NOTE
POWER CORD
Connect only to an AC 120V, 60Hz outlet.
VCR OUTPUT CHANNEL SELECT SWITCH
Set this switch to channel 3 or 4.
VHF/UHF/CATV ANTENNA OUTPUT CONNECTOR
Connect this terminal to the VHF or UHF
antenna terminals on the back of a TV.
WARNING :
Do not drop the
power cord tying band into the
unit. Doing so might cause a fire
or an electrical shock.
10
VCR SETUP
The CH3/CH4 switch on the VCR’s back panel determines
which channel the VCR uses to send video signals to your TV.
The TV must be tuned to the same channel you set with the
CH3/CH4 switch to see tape playback and status displays from
the VCR. To determine which video channel provides the best
picture for your system, try the switch in CH3 position and tune
your TV to channel 3; then try the CH4 position and tune your
TV to channel 4.
For a test display, press
TV/VCR
on remote repeatedly until
the VCR indicator light appears in the VCR’s front panel
display. Press
MENU
on the remote to see the main menu.
SET POSITION OF THE CH3/CH4 SWITCH
Tune
TV to
Ch.3
Tune
TV to
Ch.4
OR
CH.
3
4
CH.
3
4
