Zenith PRO1200X, Installation Manual

Page: 15 / 35

Installation setup
4-4 206-3610 ZENITH PRO 1200x 151199
To check the current positions of the scan switches,
proceed as follows:
Attention : This procedure can only be done after power (mains)
connection. So, first continue with the projector setup
and the connections and then return to this procedure.
•
Switch on the projector. The projector starts up on the last
selected source.
•
Press the <ADJUST> key.
•
Highlight 'SERVICE' by pushing the control stick forward or
backward and press the <ENTER> key: the 'SERVICE MODE
MENU' will be displayed.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
DYNAMIC ASTIGMATISM
MORE...
S e le c t w ith o r
th e n < E N T E R >
< E X IT > to re tu rn
•
Highlight 'IDENTIFICATION' by pushing the control stick forward
or backward and press the <ENTER> key.
The projector will display the 'IDENTIFICATION SCREEN'.
This screen gives the current information about the projector
configuration in the line entitled 'Config'.
All projectors leave the factory set for a ceiling/front configuration.
ADJUSTMENT MODE
Select a path from below:
IDENTIFICATION
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
PROVERGE
SOURCE 1
S e le c t w ith o r
th e n < E N T E R >
< E X IT > to re tu rn