11
805757NZ v1.06 07.21 Miniboil Install Instructions
Symptom
Possible Cause
Solution
No LED display, no tap head
lights or, no water when tap is
operated.
No power.
Plug is not located in power socket.
Tap loom is not connected to the
unit.
Possible internal fault.
Check power supply.
Ensure power plug is correctly fitted
and switch is turned ON.
Check loom connection.
Contact local Zenith Service
Provider.
No water flow.
Water supply isolated.
Water supply not connected.
Power supply not connected.
Tap loom is not connected to the
unit.
Possible internal fault.
Check water supply is on.
Check to ensure plumbing
connection is made.
Check power plug is correctly fitted
and switch is turned on.
Check for loom connection.
Slow water recovery after use.
Unit is in Sleep Mode.
Possible internal fault.
Touch Hot lever and wait for Red
LED to stop flashing.
Wait for Red LED to stop flashing.
Contact local Zenith Service
Provider.
All the lights are flashing
Power interruption
Water interruption
System Fault
Turn OFF power for 20 seconds and
then turn back on.
Check for blockages
Contact local Zenith Service
Provider
Do not use strong, corrosive, spray or abrasive cleaners. Clean
with a soft cloth or brush and mild soap and water.
Do not spray water over the tap as it may damage the low-
voltage electronics.
Command Centre units must never be cleaned with water jets.
In order to help preserve our environment we ask that you dispose of this product correctly.
Please contact your local city council for collection centre details.
Cleaning
End of Life Disposal
Troubleshooting
