Cloning Connections/Learning Setup
P A G E 4 0
Connections for the LT2002 Clone Programmer to Learn the L26W56X Master TV Setup.
Clone Programmer
Master L26W56X
Notes:
It is assumed that the L26W56X is connected to a signal source, the source selected is Antenna (RF) In, the signal
is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone
Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, see above and next page.
Before you begin cloning...
• The Master L26W56X should be connected to a good, stable
signal from an over-the-air antenna or cable service Analog
channel and connected to power. (See above.)
• Teaching and Learning is only possible between identical model
devices. (However, the LT2002 Clone programmer can store up
to 3 different ‘master’ setups.)
WARNING: Copying a blank or incorrect memory into a TV, STB or
other device will cause the TV, STB or other device to operate
erratically or become inoperable.
• Use an Installer’s remote to operate Learning and Teaching
menus.
• Make sure that the batteries in the Clone programmer are fresh.
• If batteries are removed, the Clone Clock time will be lost.
• Decide if you want to set the time from the Clone programmer
TV which has the clock set to the current time.
• Setting the time and transferring it to the Clone or other
device is a separate procedure.
• Follow the connection diagram above to connect the Clone to
a Master L26W56X TV display panel. After learning is complete,
to another identical L26W56X TV display panel to “teach” it
the master setup.
• After the L26W56Xs setup has been copied to another identical
L26W56X, that identical unit with the copied setup, needs to
be disconnected from power for about 15 seconds to activate
the newly-copied setup.
• See the Clone Troubleshooting section to resolve problems.
Turn to the next page to continue Cloning Setup.
Turn to the next page to continue Cloning Setup.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION
XX
THE TV IS VERSION
XX
THE SW IS REVISION
XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
QuickSet II Programmer
LT2002
¤
Ferrite Core
(TDK, ZCAT
2035-0930)
Antenna
or CATV
Warning: Do not use LT2002
if a LodgeNet PPV card is
installed in TV or clone
programmer device will be
damaged.
