A
P A G E 8
Hook Up Your Antenna and VCR
If you have a 75 ohm RF cable,
then you don’t need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AAA batteries.
Plug in your Entertainment
Machine. Do not plug it into a
switched outlet. Your
Entertainment Machine is
designed to operate on house-
hold current, 120-volt 60 Hertz
AC do not attempt to operate it
on DC Current.
Go to page 10 to Auto Program
your Entertainment Machine.
1
2
3
4
5
Connect a VCR to your Entertainment Machine.
back of
remote
TV back panel
(expanded view)
Antenna
Cable
TV back
In
Out
Audio
Video
3 4
VCR back
VCR back AV panel
Flat wire
(300 ohm)
Antenna
RF coaxial wire
(75 ohm)
not included
with TV
output
switch
Audio In Video
A/V cables
not included
with TV
206-3480
TV back panel
(expanded view)
Antenna
Cable
TV back
RF coaxial wire
(75 ohm)
not included
with TV
Audio In Video
A/V cables
not included
with TV
In
Out
Audio
Video
3 4
VCR back
VCR back AV panel
output
switch
RF coaxial wire
(75 ohm)
Antenna
Flat Wire Antenna with VCR
Antenna with VCR
Note: You will need to connect a VCR to
your television in order to use the
Picture-In-Picture feature. (See page 29
to set the signal source for your PIP)
