5
Rated voltage
220-240 V
Rated frequency
50-60 Hz
Air flow
13-19 m/s
Air temperature
300/500
0
С
Standard delivery includes set of nozzles.
intenDeD use
1.
Removing paint
On profiled surface, paint can be removed using an appropriate fitting spatula and
brushed off with a soft wire brush.
2.
Cable shrinking
Heat-shrinkable sleeve is installed on the insulation place and is heated by hot air flow.
Sleeve shrinks by 50% in diameter and seals joint. This operation is used for sealing and
repair of damaged cable, sealing of welding points, cable sheathing.
3.
Shaping plastic
Thanks to hot air flow it is possible to soften and shape plates, pipes or ski boots.
4.
Starting grill
Because of hot air flow coal will flame up at once.
5.
Defrosting
It is possible to defrost water pipes, steps or car door locks.
6.
Soft soldering
Before soldering clean the location to be soldered, warm by hot air flow and apply sol-
der. Fluxing material, protecting from corrosion is used for soldering.
7.
Welding plastic or joint loosening
All surfaces must be of the same plastic type.
ATTENTION
The power tool is designed for household usage and is not intended for industrial pur-
poses. Using the power tool in industrial purposes will make warranty null and void.
prior to operation
1. Power source.
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
2. Power switch.
Ensure that the power switch is in the OFF position. If the plug is connected to a recep-
tacle while the switch is in the ON position, the power tool will start operating immedi-
ately and can cause serious injury.
