Zenit CS-508/2300-MK, Instruction Manual

Page: 11 / 14

11
9. TRANSPORT AND STORAGE
1. Store the saw in a dry place between - 40°С and + 40°С, at a safe distance from
sources of ignition.
2. Transport and storage conditions should eliminate the possibility of mechanic
damage and influence of atmospheric fallout.
3. Store the saw out of the reach of children.
4. When storing for more than 30 days, perform the conservation:
• empty the fuel tank in a wee ventilated and clean the tank;
• start the engine and let it run till the carburetor is empty;
• wait 5 minutes and screw out the spark plug;
• pour two teaspoons of pure two-stroke oil into the combustion chamber and pull the
starter cord a few times to lubricate the internal components;
• install the spark plug.
5. Preparing the saw after conservation:
• screw out the spark plug;
• pull the starter cord several times to remove excess grease;
• clean the spark plug and set the correct gap;
• fill the tank with fuel mixture.
10. TROUBLESHOOTING
№ Trouble Possible cause Troubleshooting method
1. The engine doesn’t
start or starts but
doesn’t work.
Incorrect start proce -
dure.
Follow the instruction
manual.
Incorrect carburetor
adjustment.
Adjust the carburetor in
the service center.
The spark plug is dirty. Clean, set the correct gap
or change the plug.
The fuel filter is
plugged.
Clean or replace the fuel
filter.
2. Engine does not
give full power.
Incorrect position of the
choke control knob.
Switch the button into
operating position
The spark arrester grill
is dirty.
Clean or replace the spark
arrester grill.
The air filter is dirty. Clean the air filter
Incorrect carburetor
adjustment.
Adjust the carburetor in
the service center.
3. Engine runs errati -
cally.
Incorrect carburetor
adjustment.
Adjust the carburetor in
the service center.