4
17. Avoid unintentional starting. Do not carry a plugged in tool with a finger on the
switch. Ensure switch is off when plugging in.
18. Use outdoor extension leads. When tool is used outdoors, use only extension cords
intended for outdoor use.
19. Stay alert. Watch what you are doing. Use common sense. Do not operate tool when
you are tired.
20. Check damaged parts. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, free running of
moving parts, breakage of parts, mounting and any other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired or replaced
by an authorized service center unless otherwise indicated in this instruction manual.
Have defective switches replaced by an authorized service center. Do not use the tool if
the switch does not turn it on and off.
21. Warning Use only accessories or attachments recommended in this instruction man-
ual or in the catalogue of ZENIT ТМ.
22. Have your tool repaired by a qualified person. This electric tool is in accordance
with the relevant safety requirements. Repairs should only be carried out by qualified
persons using original ZENIT TM spare parts. Otherwise this may result in considerable
danger to the user.
safety precautions on usinG anGle Grinder
1. Always use proper guard with grinding wheel.
2. Accessories must be rated for at least the speed recommended on the tool warning
label. Use only depressed center grinding wheels rated for speed 80 m/s or more.
3. Make sure the size of the grinding wheel is compatible with size of the angle grinder
and that grinding wheel matches the spindle.
4. Store and keep grinding wheels according to the manufacturer’s instructions.
5. Before using a grinder or installing a new wheel, inspect the grinding wheel for chips
and cracks. Remove bad wheels immediately.
6. Hold the tool with both hands while starting the tool, since torque from the motor can
cause the tool to twist.
7. Never use cut-off wheel for side grinding.
8. Do not use any adapter sleeves to install grinding wheels with holes of bigger diam-
eter.
9. Don’t put tool until it comes to a complete stop.
Summary of Contents for AG-115/850
Page 1: ...Instruction manual ANGLE GRINDER AG 115 850...
Page 2: ......
