d. Wait until the process has finished. The device will then switch off by itsel.
e. Remove the USB stick from the device.
f. Switch on your device again and continue with part 4.
4. Check version
After you applied all three software updates you need to perform a version check.
BT Version
Check BT version with: Bluetooth> Setup >Seite2 > Version
Bluetooth software check after a successful update should say: HW100-SW360
MCU and MPEG Version
In order to check the MCU and MPEG versions you need the remote control. Follow these steps:
1. Insert a CD or DVD
2. Type the following keys using the remote control:
a) 2X [STOP]
b) 1X
[+]
c) 1X [UP]
d) 1X [+]
e) 1X [DOWN]
f) 1X [+]
g) 1X [LEFT]
h) 1X [+]
i) 1X [RIGHT]
Only version numbers of the MCU, MPEG (marked as DN) are of interest.
After a successful update the software version screen should say:
DN (i.e. MPEG) : 2.06
MCU :
2.08
If any deviation from the above mentioned status should occur, you can fix it by reapplying the respective part of the soft-
ware. After doing so, reassure yourself by repeating the version check until you get the desired result.
CAUTION :
If one or even more of the partial updates fail, you may encounter strange erratic behaviour of your unit. Therefore version
check and, in case of version check failure, reinstallation of the respective firmware parts are absolutely mandatory.
Note: Password
User who have altered the default password, need to type in
“012345”
as the unit resets to factory defaults during
the update.
W W W . Z E N E C . C O M
2 of 2
22
nd
of July, AL