71
ENGLISH
DISCONNECTING THE BATTERY
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery
cable prior to installation.
NOTE:
■
If the unit is to be installed in a car equipped with an on-board drive or navigation
computer, do not disconnect the battery cable. If the cable is disconnected, the preset
memory may be erased. Under these conditions, use extra caution during installation to
avoid causing a short circuit.
NOTE:
■
It is especially important that you read the
WARNINGS
and
NOTES
in this manual.
TOOLS AND SUPPLIES
You will need the following tools and supplies to install the unit.
■
Torx type, flat-head and Philips screwdrivers
■
Wire cutters and strippers
■
Tools to remove the existing radio (screwdriver, socket wrench set or other tools)
■
Electrical tape
■
Crimping tool
■
Multimeter
■
Crimp connections
■
18 gauge wire for power connections
■
16 – 18 gauge wire for speaker connections
■
Heatshrink tubing
■
Soldering iron and solder
WARNING!
1. Only connect the unit to a 12V negative ground system.
2. Never install this unit where operation and viewing could interfere with safe driving
conditions.
3. To reduce the risk of a traffic accident (except when using for rear view video camera)
never use the video display function while driving the vehicle. This is a violation of law.
4. To reduce the risk of a traffic accident, never driving with the sound at a level that
prevents you from hearing sounds outside around the vehicle.
5. Never disassemble or adjust the unit without the assistance of a professional. For
details, please consult your local car stereo specialty shop.
6. To prevent injury from shock or fire, never expose this unit to moisture or water.
7. Never use irregular discs.
8. To prevent damage to the mechanism inside this unit and avoid impact to the TFT
monitor.
9. Do not change the fuse on the power wire without professional guidance. Using an
improper fuse may cause damage to the unit and result in a fire.
10. The monitor employs an automatic motorized mechanism. To prevent damage to the
core mechanism, please do not push, pull or swivel the monitor manually.
