2
4.
Connect wires from supply and
bracket to the wiring terminals
as follow:
Brown wire “L”
Blue wire “N”
Green/yellow stripes wire “ ”
5.
Attach canopy to the bracket
by aligning canopy side holes
with the bracket side holes. Lift
fan until the screws reach the
bottom of the slots and then
rotate
the
canopy
counterclockwise until the
screws drop into the slot
recesses.
6.
Insert the other two set screws
and washers. Tighten all the
screws, make sure that the
canopy is secure and that you
have not trapped any wires.
Ensure that the slot of the nylon
ball hanger fits into the guide pin
of the upper canopy.
7.
Assemble blades shanks and
decorative plate onto fan blades
using three screws and spring
washers each.
8.
Fasten the blade assembly to
the motor with the screws and
spring washers already attached to
the motor
9.
Install light bulbs (Max.E27 60w,
not supplied) to the lampholders.
Switch the power on to check the
operation of the light kit and fan.
10.
Install the glass shade onto the
switch housing by tightening the
three thumb screws.
CAUTION:
Do not use pliers to tighten the
thumbscrews. Over tightening of
the thumb screws may crack the
glass shade and cause dangers.
11.
Attach the two pull cords,
ensure that the pull cord retaining
clips supports the cord.
Summary of Contents for J42003-XY-1L
Page 3: ...3...
