2.
Assemble the pole section. Ensure the
pole does not snap together. It is
important that the poles are fully
inserted into the ferrules. If the ferrules
do not connect together correctly they
can cause damage when tensioned.
8.
Peg out all peg points and guy
ropes, pegging at a 45
o
angle.
7.
Connect the fly to the inner by
connecting the side release buckles at
the end of each pole line.
3.
Insert the pole ends into the eyelets
found at each corner of the inner. The
RED
pole sections should be inserted
into the
RED
webbings.
Also insert the ends of each brow
pole into the eyelets found above
each door.
1.
Clear your site making sure there are no
sharp objects. Try to get a site that is as flat as
possible. Stretch out the inner tent.
1x
6.
Throw the flysheet over the
inner and fasten the Velcro
ties found on the inside of the
fly around the pole lines.
4.
Connect the inner to the frame
by connecting the c-clips that run
along each seam.
5.
Peg out the inner tent. Try to
tension the floor so that it sits flat.