7.
Pull the fly over the inner tent. The
Zempire logo should be at the front
and rear of the tent. Connect the
velcro loops inside the fly around the
cut outs on the corresponding pole
sleeve.
6.
Peg out all the peg points
around the inner tent. The peg
points at the base of each pole
should be pegged through the
webbing loop rather than the
ring.
2x
2x
2x
4.
Thread the
GREEN
poles through the
pole sleeve on either side of the central
dome. The repeat with the
YELLOW
poles at each end of the tent. Insert the
pole ends into the pin located below
each pole sleeve.
8.
Attach the elastic loop over the
existing inner pegs. Where there is
no existing peg, peg the fly directly
into the ground ensuring there is
significant space between the inner
and fly.
9.
It is recommended that guy ropes are
pegged out at all times and windows
are opened whenever possible to allow
adequate ventilation. Try to have the
guy ropes at 45 angle to the ground.
3.
Thread the
RED
poles through the
pole sleeves that run diagonally across
the center of the tent. Insert the ends
of the poles into the pin located below
each pole sleeve. Attach the C Clips
onto the poles.
1.
Clear your site making sure there are no
sharp objects where you are going to pitch
your tent. Try to get a site that is as flat as
possible. Lay out the inner (white) tent, the
round door is located at the front and rear.
The tent is symmetrical.
2x
2.
Assemble the 8 pole sections. Ensure
that the poles are inserted fully into the
steel connectors. It is important that the
poles are fully inserted into the ferrules.
If not connected correctly they can
cause damage when tensioned.
5.
Thread the
BLUE
poles through the
pole sleeve at the front and rear of the
tent. Insert the pole ends into the pin
located below each pole sleeve.
steel ring.
Insert the pole
ends into the pins located on the steel
rings at the base of the tent. Attached
the c-clips around the poles.
Insert
the pole ends into the pins located on
the steel rings at the base of the tent.
Attached the c-clips around the poles.
5.
Thread the
BLUE
poles through the
pole sleeve at the front and rear of
the tent. Insert the pole ends into the
pins located on the steel rings at the
base of the tent. Attached the c-clips
around the poles.
