Zelmer MAESTRO BARISTA ZCM8121, User Manual

Page: 29 / 85

57 56
4.6. Preparing drinks using steam
Steam can be used to froth milk for preparing a capuccino, caffe latte, or for heating up liquids.
1. Place a container underneath the steam outlet nozzle.
2. Touch the icon to switch the coffee maker on. Wait until automatic
rinsing process is finished.
3. Touch the icon Indicator will light up.
4. Touch the icon . Heating process for steam preparation will
start.
5. During preparation, indicator of the icon will flash.
6. Touch the icon to stop preparation at any time.
7. Once preparation process has finished, all the indicators
of the icons will light up permanently.
8. Wait until steam stops flowing from the nozzle before removing the container.
Note: if you want to change the amount of steam to be dispensed, please refer to section
“Adjusting user choices”
5. MAINTENANCE AND CLEANING
5.1. Emptying the drip tray
When the drip tray (4) is full, the red float (5) will become visible through the
grill, showing that the tray should be emptied and cleaned.
Proceed as indicated below:
1. Remove the tray taking it from the handle located on its bottom and pull it
out. Along with the tray, grounds collector (9) will be taken out as well).
2. Remove grounds collector. Empty the drip tray and the collector and wash them
under the tap.
3. Place ground collector on the drip tray again. Make sure it is fitted correctly.
4. Insert the drip tray into the coffee maker. Make sure it is fitted correctly.
5. Plug the coffee maker to the mains again.
5.2. Emptying coffee grounds collector
When the coffee grounds collector is full, indicator light of the icon will
light up showing that grounds collector should be emptied and cleaned.
Proceed as indicated below:
1. Remove the tray (4) taking it from the handle located at its
bottom and pull it out. Along with the tray, grounds collector (10)
will be taken out as well.
When removing the tray, indicator of the icon
will flash
2. Remove grounds collector. Empty and wash it under the tap.
3. Place ground collector on the drip tray again. Make sure it is fitted correctly.