The correction value for the aiming point is displayed approx. 1 second after
the range. A preceding “H” means that higher aiming is required
(Fig. 3)
and
a preceding “L” means that lower aiming is required. The display is given in
centimetres for the EU settings and in inches for the US settings.
For safety reason, the holding points are given only for ranges of up to
500 metres. For greater ranges, the display shows “
H I G H
”.
Selection of the appropriate ballistic programme
The selection is made using the SET button
(Fig. 1/7).
A short press of the SET
button will display the setting currently selected. An extended press of the
button for 3 seconds will cause the display to start to flash and the setting to
then change every time the SET button is pressed. The setting options are called
up successively.
The ballistic curves are numbered from 1 to 6. The EU or US presetting shows
respectively whether you have selected the measuring units of metres /centime-
tres (EU display) or yards / inches (US display).
If your riflescope is sighted in at 100 metres/100 yards, select one of the curves
from range EU 1 to EU 6 / US 1 to US 6.
If your riflescope is sighted in at SID / GEE (for EU settings only) or at 200 yards
(for US settings only), select one of the curves from range EU
▫
1 to EU
▫
6 or
US
▫
1 to US
▫
6. The superscript square indicates the longer sight in distance.
Simply release the SET button
(Fig. 1/7)
at the setting that is appropriate for
you. The ballistic curve displayed previously is then saved. In order to check, a
short press on the SET button at any time will cause the saved setting to be
displayed.
Please note that the ballistic information system
BIS
TM
is not to be used as
a replacement for the hunter’s assessment of the situation, but rather to
support and increase hunting safety. We recommend shooting exercises
from different ranges, which can be used to check the correct match of the
specifications with the actual points of impact.
24
Instructions for use
