Stand M LED
MOUNTING THE TRANSMITTED LIGHT ILLUMINATORS M LED
ZEISS
06/2016
435425-7144-008
3
Englis
h
3
MOUNTING THE TRANSMITTED
LIGHT ILLUMINATORS M LED
CAUTION
Switch off the stand and unplug the
power supply cable from the stand
before mounting the transmitted light
illuminator.
3.1
Mounting the Transilluminator
Brightfield M LED
•
Unplug the power supply cable from the
stand.
•
Gently tilt the stand backwards and put it
down.
•
Unscrew 3 mm Allen screw (Fig. 2/
1
) and put
it to one side.
•
Remove cover flaps (Fig. 2/
2
and
3
).
•
Insert the Transilluminator Brightfield so that
the two pins (Fig. 2/
4
) click into the recesses
5
) on the bottom of the stand.
•
Press the Transilluminator Brightfield against
the stand base and hold tight.
•
Screw the 3 mm Allen screw into the tapped
hole (Fig. 2/
6
) of the stand until the tip of the
screw engages in the hole of the
Transilluminator Brightfield.
•
Tighten the Allen screw hand-tight.
•
Return the stand to upright and, if necessary,
prevent wobbling by adjusting the height-
adjustable foot of the stand base (Fig. 2/
7
).
•
Plug the power supply cable back into the
stand.
Fig. 2
Mounting the Transilluminator
Brightfield M LED
