Zeiss S100, Instructions For Use Manual

Page: 15 / 278

Version 9.0
G-30-1781-en
Page 15
S100 / OPMI pico Safety measures
• To make sure that accessories do not fall down, check before each use
that they are firmly seated and the securing screws are firmly tightened.
• Always route cables so that they do not hinder the user.
• If you operate the device in a sterile area, make sure that you use the
corresponding sterile accessories for the device.
• Make sure that the operating staff is briefed about the sterile operation of
the system.
• Never cover any ventilation openings, as the light source of the system
switches off in the event of overheating.
• Never use force when trying to connect any electrical connectors (plugs,
sockets). If the connection cannot be made easily, check whether the plug
fits the socket. If you detect any damage to the plug-in connection,
arrange for the damage to be repaired by ZEISS Service.
• Please refer to the functional test in chapter "Operation" (Page 129).
More specific information about the floor stand:
•
Press the locking tabs on the stand base to secure the stand in position.
Make sure that the stand is stable and cannot roll away.
During use
• Reduce the brightness and duration of light exposure of the surgical area
to the absolute minimum level required to avoid burn injuries.
• Never look directly into the light source, e.g. the microscope objective lens
or light guide, as this may cause phototoxic injury to the eye.
• Never leave a device unattended when its light source is switched on.
• Defective or unapproved accessories may lead to increased leakage
current on the device. Do not connect any defective or unapproved
accessories to the device.
• Never touch the video interfaces or other signal interfaces while you are
in contact with the patient.
• If you replace the lamp shortly after it has failed, the lamp will still be very
hot. Use heat-resistant protective gloves when replacing the lamp to
prevent burns.