Zeiss OPMI Lumera i, Instructions For Use Manual

Page: 81 / 184

Version 8.0
G-30-1720-en
Page 81
OPMI Lumera i Preparation for use
Positioning the device in the OR
Proceed as follows to position the system:
• Release all locking devices.
• Hold the device by the transport handle (1) and move it carefully into
a position convenient for you (such as that shown below).
– Make sure that carrier arm (2) and suspension arm (4) are not fully
extended but are positioned at an angle. This provides a greater
degree of maneuverability and also a perfect working position.
– Ensure the device is standing on even ground.
• Press at least two of the locking tabs of the casters (3) and make sure that
the stand is no longer able to roll away by itself.
Fig. 31: Top view of the
working position
1 3 3 2 4