Zeiss OPMI Lumera i on floor stand, Instructions For Use Manual

Page: 137 / 178

OPMI Lumera
®
i on floor stand Care and maintenance
Version 9.2
G-30-1720-en
Page 137
Sterilization
The Asepsis Sets available from ZEISS contain rubber caps and handgrips
which can be sterilized in autoclaves. For detailed information on sterilization,
please see the enclosed instructions “Preparation of resterilizable products”
for the respective Asepsis Set.
You can also use disposable sterile drapes to cover the system.
•
When draping the system, make sure there is enough slack in the drapes
to allow for movement of the microscope carrier and surgical microscope.
•
In order to ensure that the lamps are able to cool sufficiently and to avoid
any loss in lamp functionality, take care not to cover the ventilation slots.
Disinfection
It may be necessary to disinfect the surfaces.
The maximum concentrations for application are:
– For alcohol (tested with 2 propanol): 60 %
– For aldehyde (tested with glutaraldehyde): 2 %
– For quaternary compounds (tested with DDAC): 0.2 %
NOTICE Surface damage caused by use of wrong disinfectants!
Performing disinfection with the wrong disinfectants may result in damage
to the surfaces of the device.
•
Use an aldehyde and/or alcohol-based disinfectant. The addition of
quaternary compounds is acceptable.
•
In order to prevent surface tensions, you may only use the disinfecting
components specified below.