Zeiss OPMI Lumera i on floor stand, Instructions For Use Manual

Page: 129 / 178

OPMI Lumera
®
i on floor stand What to do in the event of malfunctions
Version 9.2
G-30-1720-en
Page 129
Malfunctions of the FCP foot control panel
Error messages on the 5.7 ″ control panel
In the event of malfunctions occurring during operation, an error message
is displayed on the 5.7
″ control panel.
•
Check and eliminate the malfunction.
•
Acknowledge the message.
The following table contains examples of error messages and the corre-
sponding remedies. If you have problems eliminating the malfunction,
or if errors keep recurring, do not continue using the system and contact
ZEISS Service.
You will find the contact responsible for your country on the following
website: www.meditec.zeiss.com
Malfunction Possible cause Remedy Reference
Foot control panel is
inoperative. Connections on stand or
foot control panel not
plugged in. Plug in connections. Page 81
Error message Possible cause Remedy Reference
XY coupling error. The error
can be acknowledged.
If the error impairs your
work, please switch to the
manual mode and contact
ZEISS Service.
– e.g. hardware error in
motor electronics
– e.g. software error,
motor control in
forbidden status
If the error impairs your
work, switch to the
manual mode. Page 125
Light source error. The error
can be acknowledged.
If the error impairs your
work, please switch to the
manual mode and contact
ZEISS Service.
– e.g. malfunction of light
intensity setting If the error impairs your
work, switch to the
manual mode. Page 125