Zeiss MMZ M, Operating Instructions Manual

Page: 95 / 154

What you should know!
61211-1270302 MMZ M
7-3
Probing and scanning
Workpieces may be probed from any directions. The illustration shows
the possible probing directions and the scanning of a bore.
Using the measuring software, it is also possible to probe oblique sur-
faces perpendicular to the probing surface. See operating instructions
for the measuring software.
NOTE
Clamp a workpiece before probing. Otherwise, the workpiece may be
shifted by the probing. Correct measurement is not possible if the work-
piece is shifted.
NOTE
In the ideal case, probings should be performed perpendicular to the
probing surface.
Tips for effective operation
Changing the stylus systems automatically
If several stylus systems are required for workpiece measurement, you
should note which stylus system you have assigned to which holder. If
more stylus systems are required than can be accommodated by the
changer rack, it is possible to mount additional changer racks.
Do not switch off the CMM if ...!
The start-up procedure involves a number of worksteps which take a
while to perform. Furthermore, the CMM should have been in operation
for a prolonged period before performing the first measurement. You
can save time by leaving the CMM switched on.