Operation
15
626109-9160-000 FixAssist XTR Operating manual V1.0
4.3
Configuring the angle around the second
axis
Requirements:
– A probe system with extension and probe is fixed in the plate support.
– The angle around the Z-axis is configured.
1.
Insert the centring aid (
1
)
into the prism slide.
1
2.
3.
4.
5.
Release the fixing screw of
the vertical and horizontal
guide.
Push the centring aid
carefully both vertically and
horizontally until the tip of
the probe is precisely in the
centre.
Re-apply the fixing screw of
the vertical guides.
The prism is now set to the
correct height.
Push prism slides
horizontally. Remove the
centring aid and probe
once again,
Fig. 13:
Fig. 14:
Summary of Contents for FixAssist XTR
Page 1: ...FixAssist XTR Probe presetting device for probe systems with XTR plate Operating manual...
Page 2: ......
Page 19: ......
