Checking the safety devices
61211-1310402
CONTURA
2-17
v
x
F
v
X
:
Ram speed in the X axis
F:
Force which must be exerted manually against the housing cover of the
ram.
Under normal circumstances, the force of your hand should suffice to
stop movement. If the movement cannot be stopped in this way, the
protective circuit must be checked immediately by a ZEISS service engi-
neer.
NOTE
If you can stop the travel movements, you will need to reactivate the
drives. See control elements.
Y-Axis
Components may be damaged by improper handling.
The probe, ram, and left column could be damaged.
ü
You may only push against the right column of the bridge.
Do
not
push against the probe and do
not
push against the left col-
umn of the bridge.
1
Move the control console to the
drive side
for Y axis travel.
The drive is located on the
right
side of the CMM.
Summary of Contents for CONTURA
