Zeiss CIRRUS HD-OCT 500, User Manual

Page: 46 / 352

Station Setup
2660021169012 Rev. A 2017-12 CIRRUS HD-OCT User Manual
4-2
3. Add the value of the Issuer of Patient ID in this field. The Issuer of Patient ID field
denotes assigning authority of patient IDs entered at a particular site or practice. As a
recommendation, it should be set to the same value on every instrument in the
practice and to the same value as in the leading patient information system, if
applicable. If the Issuer of Patient ID already exists—for example, the same one used
in the previous software version—the value appears in the
Issuer of Patient ID
field, where it can be edited, if desired. Changes made to the identifier of the Issuer of
Patient ID will be applied to patients going forward; the change will not appear on
patient information already in the database.
4. Add Institution Logo Graphic (Optional). The graphic must be in bitmap format (.bmp).
Use Browse to navigate to the graphic file of your choice. The selected file will appear
in the Preview pane, which is 150 pixels square (1.9 cm or 0.75 inches square at 200
pixels/inch), and will be stretched or constrained to fit it. The graphic will then appear
in these proportions on analysis reports, though in a smaller size.
5. Click Save to save your changes and exit the dialog, or click Close to exit the dialog
without saving.
NOTE: You must restart the CIRRUS application to cause changes to the Institution Name to
appear in the header of reports.
Station Setup
For every instrument or Review station, a unique station name and AE Title must be
specified in order distinguish CIRRUS HD-OCT instruments, Review Stations, and any
additional CZMI equipment your institution may use.
To access the Equipment Edit dialog, you must be logged in as the
Admin
. Follow these
steps to create (or edit) the station name of the instrument:
1. From the Toolbar select Tools > Options > Equipment Edit. An example dialog box
appears as shown in Figure 4-2 .
cáÖìêÉ=QJO==bèìáéãÉåí=bÇáí=aá~äçÖ