Axioskop 2
plus
START-UP
Axioskop 2
mot plus
Attachments and conversions
Carl Zeiss
B 40-075 e 10/03
2-31
2.2.16
Attachment of active coobservation equipment for 2 users
The active coobservation equipment for 2 users can only be attached to a Axioskop 2
plus
/
Axioskop 2
mot plus
microscope stand if the incident-light illuminator (e.g. HBO 103) has been removed.
•
Use SW 3 ball-headed screwdriver to loosen clamping screw (2-46/
) and remove available tube in an
upward direction.
•
14
) from the dovetail at (2-46/
) of the coobservation equipment (2-46/
).
•
Insert dovetail of coobservation equipment in the stand opening (2-46/
) and tighten clamping screw
) only slightly at first.
•
Align coobservation equipment with the outer edges of the stand and make sure that the support
points on the coobservation equipment (below) and the stand (2-46/
) match exactly.
•
Then tighten clamping screw (2-46/
12
) to prevent the coobservation equipment from shifting.
•
Unscrew the tube lenses from the two binocular tubes (using the cover of one of the storage cases)
and put them in the cases.
•
and
18
) from the coobservation equipment.
•
17
) of the coobservation equipment allows attachment of either the binocular
) or the ergo-phototube 6-25°/23 (100/100). The rear dovetail
) allows not only the attachment of the two ergotubes, but also of the binocular tube 30°/23
) or the binocular phototube 30°/23. Then align the tubes and tighten clamping screws
and
19
).
The binocular ergotube and the ergo-phototube 6-25°/23 provide an upright and unreversed image of
the specimen in the eyepiece.
•
Screw heat protection shield (2-46/
) to coobservation equipment from below using two fixation
).
•
, 115 V or 230 V) in the socket (2-46/
5
) on the
coobservation equipment and tighten the screwing ring to prevent shifting.
•
Connect power unit to the line (115 V or 230 V).
