START-UP
Axioskop
2
plus
Carl Zeiss
Initial start-up
Axioskop 2
mot plus
2-4
B 40-075 e 10/03
2.1.2
Attachment of binocular tube or
phototube
All the binocular tubes included in the microscope
configurations listed in section 1.3 or 1.4 can
be attached to the Axioskop
2
plus
/ Axio-
skop 2
mot plus
as described below.
•
Loosen hexagonal screw (2-2/
) using the SW3
ball-headed screwdriver. Remove dust covers (2-
2/
) from the tube underside and the dovetail
mount on the stand.
•
) or the binocular
phototube in a slightly inclined position and
attach it to the stand mount (2-2/
4
). Turn the
binocular tube in the required observation
position and tighten the hexagonal screw using
the ball-headed screwdriver.
2.1.3
Insertion of eyepieces and
centering telescope
•
Remove both dust covers (2-3/
and
4
) from the
binocular tube.
•
2
) from the cases
and insert them in the binocular tube until stop.
•
3
), which is used
to view the aperture/phase/darkfield stops and
to center phase and darkfield stops, can be
inserted in one of the tubes instead of an
eyepiece. The adjustable eyelens permits
focusing on these stops and the setting to be
fixed using a clamping screw.
☞
The eyepieces W-PL 10x/23 Br. foc. and PL 10x/23 Br. foc. can be used with all tubes
(see pp. 1-6, 1-10).
Fig. 2-2
Attachment of binocular tube
Fig. 2-3
Inserting the eyepieces
