Zeiss Axio Examiner, Operating Manual, Page: 27 / 96

START-UP
Axio Examiner Installing standard components Carl Zeiss
M60-2-0003 e 05/2012 27
3.1.2 Fastening the microscope to a
tabletop
The lower microscope part has three screws for
fastening the microscope to a perforated panel.
Proceed as follows:
•
Remove the condenser carrier, if any (see
section 3.1.9).
•
Align the microscope.
•
Screw in and tighten the screw located inside
the upper microscope part (Figure 3-2/
1
) and
the two screws at the rear side (Figure 3-2/ 2 ).
•
Attach the condenser carrier again if required
(see section 3.1.9).
3.1.3 Attaching a binocular tube /
phototube
Every binocular tube included in the system
overview (see section 2.2) may be attached to the
Axio Examiner stand. Proceed as follows:
•
Loosen the hexagon socket head screw
(Figure 3-3/
3 ) using a ball head-screwdriver,
width A/F 3. Remove the dust caps (Figure 3-3/
2
and 5 ) from the tube bottom side and from the
stand's dovetail socket.
•
Attach the binocular tube (Figure 3-3/
1
) by
inserting the dovetail ring into the socket
(Figure 3-3/
4 ). Rotate the binocular tube into
the desired viewing position, and tighten the
hexagon socket head screw (Figure 3-3/
3 ) using
a ball-head screwdriver again.
Figure 3
-
2 Fastening the stand to a tabletop
Figure 3-3 Attaching the binocular
(photo)tube