18. May 2021
© Copyright 2021, PROCEQ SA
6
4.1 Display
The ZGM 1130 is equipped with a touchscreen (1) in order to receive inputs from the user.
4.2 Measuring Button
The measuring button (4) is used to start, stop measurements or to switch the device off if
configured. It is also used to exit the menu from any point and return back to the measuring
window. Beside this it has the following functions:
Trigger a single measurement
Start / stop a scan measurement
Start / stop interval measurements
4.3 Power Supply
The ZGM 1130 is powered by an internal rechargeable battery which can be charged over
the USB port. Either a standard PC USB port or a high power USB charger like included in
the delivery of the ZGM 1130 can be used.
However, special attention should be payed to the USB cable since fast charging can only
be reached when the supplied cable is used.
If the device is charging,
will be displayed in the upper right corner of the display.
Only a Zehntner Service Center is allowed to replace the battery.
4.4 Automatic System Check
The ZGM 1130 provides an automatic system check functionality. The device is turned on
when placed on the calibration standard a system check will be performed during the startup
phase. Whenever needed, the system will inform you about possible issues and instruct you
to carry out the necessary steps to eliminate the problem.
4.5 Connectivity
The ZGM 1130 is equipped with a USB interface (2) which
allows to download measurement files and to control the
device. In order to use the ZGM 1130 together with the
“GlossTools” software
, the software needs to be installed
first. To connect the ZGM 1130 with a PC no additional
drivers are necessary. If the device is connected the first
time to a PC, the necessary driver will be installed
automatically. When the ZGM 1130 is recognized by the PC
the shown pop up window appears on the touchscreen
where three different connection modes are available.
4.5.1 Charging only
In charging mode the device will be charged from the PC over USB but no data connection
will be established. This mode is used when further measurements should be taken with the
device but the battery is critically low.
