Installation (Please refer to illustration):
Step 1. Take the pole attached , and then plug into the hole shown in illustration
to keep it standing.
Step 2. Take the IEC cable attached, and then connect one end to the IEC port,
and the other end to your DVB-T receiver shown in illustration
Attention! Don´t connect to a Satellite-Receiver!
Step 3. Take the power adaptor attached and Insert the end of DC connector into
DC jack on the back of AA03, and then plug in the A/C end.
***** If your DVB-T receiver (e.g. Zehnder TX 60) supplies with 5 VDC from
IEC connector, then it is not necessary to use the power adaptor.
Step 4. Connect your receiver and your TV by Scart Cable (see receiver manual)
and switch them on.
***** If your DVB-T receiver supplies with 5 VDC, ensure in the set-up menu
of the receiver, that the power supply to the antenna via the coax
cable is switched on.
6
Tips for correct Antenna Adjustment
To verify the quality of reception, you can use either
the TV picture or the option of displaying the
reception level and signal quality in the set-up menu
of your receiver.
If reception is subject to interference, turn the
antenna slightly, or alter the direction of polarisation
by titling it sideways (horizontal – vertical), and check the quality of reception.
If it is impossible to get optimum reception, set the antenna up in a different
place (we recommend a position close to a window), and repeat the steps
described above.
