- 13 -
30.
PV CURVE SW
Enabling, or disabling PV curve switch for changing PV curves while riding.
Enter
Set PV
menu and move to
PV Curve SW
with pressing + or - and then press enter .
Now you can enable, or disable
PV Curve
switch with pressing + or - and then press enter .
31.
MECHANICAL SETTINGS (Static Angle)
Static Angle
is ignition advance angle, set with stator (generator).
Measure this angle with dial gauge. This measured
Static Angle
is your maximum advance
angle you can set with
PDCI
.
Calculating mm to deg or vice versa:
32.
MONITORING
Connect
programmer
to
PDCI
and wait few seconds for activation of
programmer.
Fist
information displayed on the
programmer
is software version.
With
programmer
you can watch revs, calculated advance ignition angle, TPS
position...depends on setting in the menu.
Information!
You can connect or disconnect
PDCI
unit from
programmer
any time you want, without any
harm. It is not important, if motor running or not and if power supply is connected or not.
Important!
Do not use too much force when connecting or disconnecting
programmer
unit!
33.
ERROR REPORTS
PVerr 1
– position sensor error or servo motor disconnected
PVerr 2 –
servo motor error (short connection)
