Zebex Z-3272 Plus, User Manual

Page: 25 / 205

2D Image Gun ‐ Type Handheld Scanner 15
U
SER
’
S
M
ANUAL
Using the Scanner
Beeper Indication
Beeps Indication
3 beeps in a series from low to high pitch
Power up
1 short beep
A barcode has been successfully decoded
2 short beeps
The scanner has entered program mode
1 long beep A setting has been programmed
3 beeps in a series from low to high pitch The scanner has exited program mode
3 short beeps Error setting the scanner
Scanner Operation
Please follow the procedure below to verify scanning operation.
1. If necessary, plug the power adapter into the jack on the interface cable.
2. Plug the AC end of the power adapter into an AC outlet, or plug the other end of
cable into host if power adapter is not needed. When power is supplied, the
scanner powers up, the speaker sounds beeps and the LED indicator glows.
3. Present a known ‐ good test barcode to the scanner. The scanner should issue a
short beep and the LED should flash red momentarily.
1. If the scanner is connected to a USB for this test, it should read one
barcode, beep and then flash a blue LED indicating light. This is
normal when the USB is not connected to a live host terminal.
2. If the scanner does not produce any beeps, or produces the wrong
beeps, or the LED does not light up, remove the power connection
and refer to the Troubleshooting section.