Start of Configuration
RESET
•
The reading of the "RESET” label
turns all the parameters back to
default values.
•
When you intend to turn your
scanner back to default
parameter, please scan the
"Start of configuration" label first,
then scan "RESET" label
and
finally scan the "End of
configuration" label.
ABORT
RS-232C
PC/AT
WAND EMULATION
SHOW VERSION
•
The reading of the "ABORT" label
discards all the parameters read
prior to the "End of
configuration".
•
The scanner remains in the last
interface mode when the
scanner is reset. The label
below should be scanned if the
scanner is configured the first
time.
•
The reading of the “ SHOW
VERSION” label will be show
firmware version.
SCANNING MODE SELECTION(for laser scanner)
For series laser scanners, there are 3 scanning modes to
suit your application requirements.
Trigger Mode
Turbo Trigger Mode
The scanner becomes inactive as
soon as the data is transmitted. It
must be triggered to become active
again.
The scanner switch is pressed and
double reading for the same bar
code is permitted. The scanner
will turn off when the trigger switch
is released.
6
Without any scanning, the unit will
enter a standby mode. To
reactivate the unit, present an
object in front of the IR sensor.
(*Only for Alpha-60 series.)
Object detect Trigger
Note: To avoid hazardous exposure, all laser scanner are
equipped with an internal cut-off security system
which will turn off the laser beam after 5 seconds.
SCANNING MODE SELECTION (For Alpha-70
series)
The scanner becomes inactive as
soon as the data is transmitted. It
must be triggered to become active
again.
In auto scan mode, the scanner is
still active after the data is
transmitted, but the successive
transmission of the same bar code
is not allowed when the trigger
switch is pressed again.
This scanner will light up when
press the scanner trigger switch
once. And, the scanner will turn
off for next pressing.
For testing the response of the
scanner.
For factory testing use only.
Trigger mode
Auto scan mode
Alternate mode
Repeat mode
Testing mode
DATA REDUNDANT CHECK
The option allow you to set decoder
data redundant check.
Enable
Disable
End of Configuration
7
