Zeagle ReZort 310-5210, Owner'S Manual

Page: 15 / 19

13
It is essential that your regulator is checked at least annually by an
authorized Zeagle regulator technician. Unusually heavy use, or use
in dirty or contaminated water may result in the need for more frequent
service. A service record has been provided at the end of this manual to
assist you in keeping your regulator’s service up to date.
MAINTENANCE
2. With the dust cap securely in place, rinse the first and second stage
in clean fresh water. DO NOT purge the regulator before or during rins-
ing since this may introduce water into the second stage and the low-
pressure hose. After rinsing, reconnect the regulator to an air supply
and thoroughly shake all excess water from the second stage. Press
the Purge cover (with the regulator attached to a pressure source) sev-
eral times to blow the rinse water out of the inner mechanism. Allow
the entire regulator to air dry before storing. For reasons of hygiene,
equipment subjected to frequent use in training, rental, etc. should
finally be rinsed in water containing a suitable sterilizing agent. The best
sterilizing solutions for your regulator are soap based. If any stronger
chemicals are used, make the immersion very brief and rinse the regu-
lator out again thoroughly. Failure to rinse sterilizing chemicals out of
the regulator will cause serious damage to plastic parts of the regulator.
This will result in cracking of hard plastic parts and shrinking or swelling
of soft plastic parts.
NOTE : DO NOT USE SOLVENT CHEMICALS TO CLEAN THE
REGULATOR.
3. Store the clean dry regulator in a clean bag or storage box, away from
sunlight, excessive heat and humidity.