11
There are only minor differences on a twin cylinder model. The rubber
“non slip” plate should be completely installed on the bottom band oppo-
site the touch fastener (Velcro) material on the band, before inserting the
band under the webbing on the pack. The bands go under the vertical
webbing on the back plate. If your system has only two pieces of vertical
webbing, it is not a twin cylinder model and should not be used with twin
cylinders. If you are setting up a double pack for single cylinders, please
note that the single size cylinder bands only go under the center 4 inches
(10.2 cm) of vertical webbing on the back plate and the rubber plate is
installed as illustrated on pages 10 and 12.
Threading The Standard & Quick Release
System On A Twin Cylinder Back Plate
Fitting and Assembly
Standard System
Optional Quick Release System
• An alternate method of attaching twin cylinders with steel bands is by bolting
through the back plate grommets.
• Optional band extension used only with quick release band for twin cylinder use.
• Extension strap should be adjusted at cylinder buckle hook end for proper cylinder
size.
Back Plate Grommets
Optional Band Extension
