3.
Secure the plate with two screws (without
washer) using a torx screwdriver.
The below figure shows the SIM card installed
and the SIM access plate closed.
STEP 2: CONNECT THE ANTENNAS
1.
Attach the two included LTE antennas on
the connectors labeled LTE1 and LTE2 on
the ZLF-372 and one GPS antenna to the
USB connectors on the ZLF-372.
LTE Antenna Installation
GPS Antenna Installation
2.
Position the antennas so they suit your
deployment scenario.
STEP 3: ATTACH THE CABLE COVER
The ZLF-372 comes with a plastic cable cover to
hide AP’s power and antenna connectors to
prevent removal of power and antenna cables.
1.
Clear cutouts on both sides of cable cover
marked in red.
2.
Route the antenna and power cables out of
the access slots on either side of cover.
3.
Align the tabs on the cable cover with the
slots on the bottom of the ZLF-372 and slide
into place.