zBOOST® YX645 USER GUIDE
ii
zBOOST® YX645 USER GUIDE
iii
Cet appareillage numérique de la classe [B] répond à toutes les exigences de l’interférence canadienne
causant des règlements d’équipement. L’opération est sujette aux deux conditions suivantes: (1) ce dispositif
peut ne pas causer l’interférence nocive, et (2) ce dispositif doit accepter n’importe quelle interférence reçue,
y compris l’interférence qui peut causer l’opération peu désirée.
Le fabricant nominale de la puissance de sortie de ce matériel est simple transporteur. Pour les situations
lorsque plusieurs signauxporteurs sont présents, l’évaluation devrait être réduite de 3.5 dB, en particulier
lorsque le signal de sortie est ré-émise et peut provoquer des interférences adjacentes à la bande utilisateurs.
Ce pouvoir est de la réduction par le biais de la sortie d’alimentation ou la réduction de gain et non par un
atténuateur à la sortie du dispositif.
Please note: Th
is unit has been approved for use in Canada under RSS 131, however, consent for the use of
this device to improve cellular or PCS coverage, must be obtained through your cellular or PCS provider,
prior to placing the unit in operation. Please refer to the Industry Canada document CPC 2-1-05, Section
6.1 available or viewable at:
http://www.ic.gc.ca/epic/site/smt-gst.nsf/en/sf08942e.html
Copyright Notice
Th
is manual is copyrighted. All rights reserved. Th
is manual, whole or in part, may not be copied,
photocopied, reproduced, translated or reduced to any electronic medium or machine readable form for
distribution. Th
is manual whole or in part, may not be modifi ed without prior consent, in writing, from
Wireless Extenders.
Copyright © 2010 by Wireless Extenders, Inc.
Trademarks
Wireless Extenders, Wi-Ex, the Wi-Ex logo, zBoost, the zBoost logo and Extending Cell Zones are registered
trademarks of Wireless Extenders, Inc.
Safety Guidelines
In accordance with FCC requirements of human exposure to radiofrequency fi elds, the radiating element
(antenna) shall be positioned such that a minimum separation distance of 8 inches (20cm) is maintained
between the radiating element and the user and/or general population.
Limited Liability
In no event shall Wireless Extenders be liable for any direct, indirect, special, punitive, incidental,
exemplary or consequential damages, or any damages, whether in an action under contract, negligence,
or any other theory, arising out of or in connection with the set up of, use of, inability to use, or
performance of the information, services, products, and materials available from this manual. Th
ese
limitations shall apply notwithstanding any failure of essential purpose of any limited remedy. Because
some jurisdictions do not allow limitations on how long an implied warranty last, or the exclusion or
limitation of liability for consequential or incidental damages, the above limitations may not apply to you.
For full warranty guidelines, see page 16.
Safety and Product Warranty Information
Changes or modifi cations not expressly approved by
Wi-Ex® could void the user’s authority to operate this
equipment and/or void the product warranty.
Package Contents: zBoost® YX645
Before you begin, make sure all of the following parts came with your zBoost® YX645.
Item
Quantity
Part #
Description
1
1
DMAN-0043
YX645 Setup Overview
2
1
DMAN-0041
YX645 Manual
3
1
APCA-0031
YX645 Base Unit
4
1
CPSP-0009
Base Unit Power Supply, White
5
1
YX031-10W
10’ RG-8X extension coax
6
1
YX027-PCS-CEL
6/9 dBi Directional PCS-CEL Indoor Antenna
7
1
YX021-CEL
8 dBi Directional CEL Outdoor Antenna
8
1
YX023-PCS
13 dBi Directional PCS Outdoor Antenna
9
1
YX015D
Dual Band Outdoor PCS-CEL Signal Combiner
10
1
AHDW-0002
Hardware Kit (anchors, feet, screws)
Note