4
LED Indicator
LED
Color
Indication
Network
Blue
Solid blue when network is established.
Blink blue when there is network activity.
Power
Red
Solid red for booting up process
Blue
Solid blue for booting up completion
Purple
Blink purple during: (a) firmware upgrade, (b) reset
button pressed for at least 5 sec to factory default.
Unlit
When reset button is pressed or when power off.
Power Mode
PoE Mode
Power Requirement
PoE (IEEE802.3af) with Class 3
Power Consumption
4.19 W
Adaptor Mode
Power Requirement
12V/1A Adaptor
Power Consumption
4.24 W
Install the hardware and connect all cables
A.
Hardware installation
1)
Loosen the tamper-proof screws using supplied L-type hex key wrench and
remove the dome cover. Be careful not to scratch the dome cover.
2)
You may feed the cables through the upper conduit hole or the side conduit
hole. Please use the supplied blind pug to seal the unused conduit hole.
3)
Side conduit hole installation: Disassemble the cable gland first and feed the
network and I/O cable through the sealing nut, claw and cable gland. Connect
the cables to the camera. Attach the cable gland to the conduit hole. Push the
claw into the cable gland and tighten the sealing nut to secure the cables.