3. INSTALLATION
4
The heater is packaged with the feet unattached. You must attach them before
operating the heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright
position (feet on the bottom, controls on the top), any other position could create a
hazardous situation.
1. Place the radiator body upside-down on a scratch free location, make sure it is
stable and will not fall.
2. Screw off the wins nuts from the U-shaped bolt provided, attach the U-shaped bolt
to the U facing flange between first and second fins (near the front cover).
3. To attach the castor mounting plate to the radiator body, you should insert the
threaded ends of the U bolt in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5. Screw off spherical nut from the castor, align the shaft to the hole of the castor
mounting plate, inserting, and screw on the spherical nut.
6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the rear castors.
Note: the rear castors must be mounted between the end two fins.
2. KEY TO MACHINE PARTS (Page 2)
1
A/B/C
A/B/C
A/B/C
A/B/C
A/B/C
A/B/C
C
2
3
4
5
6
7
- Thermostat knob;
- Power switch;
- Power indicator;
- Cord storage;
- Castor;
- Radiant fins;
- Fan heater;
