Zass ZASD 02S, Operating Instructions Manual, Page: 5 / 14

4. SPECIFICATION
1.
As is shown in Fig. One, (1) (2), open the shell cover.
2.
As is shown in Fig. Two, drill a 4- ɸ 6 mounting hole in the install location, and put
rubber cork that come with randomly in it, then tighten screw that come with randomly
on the install location.
3.
As is shown in Fig. [B] on page two, pull the battery cover in the direction of the
arrows, put 4 pieces C type batteries (1.5 V) in it and close cover. If use DC power
without battery, you can put DC power plug in the 220 power outlet, insert other end in
DC power connecter of battery box.
4.
Open bottle cap and pour sterilizing liquid / hand sanitizer into container, then put
the cap back on the bottle. The maximum capacity is 1000 ml.
5.
Press the pump several times in order to eliminate air of the pump the first time
you use.
6.
After closing the shell cover, then it can be used normally. The indicator light is
green when it works.
7.
Put your hands under the nozzle zone within 8 cm using the item, it will spray
about 1 ml once automatically. The sterilizer would spray once every three seconds
if hands within the range of reaction. It will stop automatically after spraying 9 times
continuously and the indicator light will be red for warning.
5
English
Model
Power supply 1
Power supply 2
Dosage mode
Ideal for
Capacity
Sensor
Volume dosage
Installation
Material
Dimension (cm)
ZASD 02S ZASD 02D
AC 220/50Hz, ≤20W
(power supply included)
AC 220/50Hz, ≤20W
(power supply included)
DC 4 x 1.5V type C batteries (not included) DC 4 x 1.5V type C batteries (not included)
Spray (for low density liquids) Drops (for gel liquids)
Body lotion, liquid soap, shampoo, disinfectant
gel, dishwashing liquid detergent, etc.
Liquid disinfectant, alcohol, alcohol,
cologne, etc.
1000 ML 1000 ML
Built-in infrared, induction distance
8cm ± 1cm
Built-in infrared, induction distance
8cm ± 1cm
0,8-1,5 ML 0,8-1,5 ML
Mounted on the wall Mounted on the wall
ABS ABS
12.5 x 26 x 11 12.5 x 26 x 11