2.
The resident can
reply the call by pressing PTT
K3. Now handset signal icon will stay on
and the transmit icon (lightning) shows up every time K3 is pressed. Speak only after the
two beeps sound or otherwise the visitor will loose some of your words. Release K3 after
finish speaking and the unit enters reception mode with the transmit icon going off and
receive icon showing up in LCD. The resident can speak to the visitor anytime they prefer
by pressing K3.
3.
In case the handset
does not reply
the call within the time period as set by the ringing tone
time (10 sec or 15 sec or 20 sec), both handset and gate station will return back to standby
mode automatically.
4.
For house no. paired with
more than one handset
, whenever the gate station calls, all
handsets will start to show call alert sign. Only one handset can answer the call, the
remaining handsets will enter Tx inhibit mode so as not to interfere with the
communication.
5.
To
activate relay
A or dry contact B, press K4 or K5 respectively. The gate open icon X18
will show up momentarily in LCD together with the respective letter A or B once the gate
station receives such command successfully.
6.
Upon
finishing communication
, the resident can hang up by momentarily pressing K2.
Both handset and gate station will return to standby mode. In case the resident forgets to
hang up, the handset will hang up by itself approximately 1 minute after no activity has
been detected on any button.
7.
During a call
, all other handsets in the system (programmed with different house no.) will
enter Tx inhibit mode so as to avoid interference to the call under progress.
8.
Under standby mode
, the handset can speak to the gate station by pressing PTT K3, but the
gate station cannot talk back. The handset can also activate relay A or dry contact B by long
press of K4 or K5.
9.
If there are more than one handset programmed with same house no., the
handset can call
each other
by pressing K1.
10.
The
battery can be charged
up by placing handset in the supplied charger stand. During
charging, the red LED on the charger stand starts flashing and turns steady green once the
battery is fully charged up.
11.
Beep sound will be heard for each valid entry of button.