12
Speaker Wiring of the Z-II Class AB Amplifiers
The Very Basics
• No speaker wires can be shorted to, or touching either ground or each other.
This will put the amp into protect and may damage the amplifier
• When bridging the left and right channels of any amplifier, you use the
left channel (Ch1) positive and the right channel (Ch2) negative, as indicated
on the chassis by the speaker terminals
Z-150.2 II Speaker Wiring
Stereo Mode
• Commonly a pair of full range speakers with x10 swt. off (out or x1 position)
and HPF set between 70Hz~100Hz to protect the speakers from deep bass.
• To use for tweeters put Multiplier switch to x10 (pushed in) and set HPF
between 2000Hz~5000Hz, as per the tweeter makers recommendation
• To use for midrange: Determine the range of frequencies you want. Put the
LPF/BPF Multiplier switch to x10 (pushed in) and set the LPF filter to the highest
frequency you want to have. Set the HPF filter to the lowest frequency you
want to have
Single Channel Mode
Bridged to one voice coil using L+ and R-
• Commonly for a woofer. Set crossover mode to LPF/BPF with Multiplier to off (x1)
• Set LPF freq. to woofer maker’s recommendation. Set HPF crossover freq. to
20Hz to use as a sub sonic filter
Summary of Contents for Z-150.2 II
Page 27: ......
Page 28: ...1 Modesto California USA Since 1974 zapco com...
