zapco SEQ, User Manual

Page: 4 / 13

Installation Instructions
The cable supplied with your SEQ is comprised of seven wires. These
seven wires are terminated on one end in a connector designed to be
inserted into the back of the SEQ. The other wire ends have been left
unterminated.
The following are instructions on proper connection of the seven
unterminated wire ends and additional wiring to ensure proper system
grounding.
WIRES INSIDE SHIELDED CABLE:
Five wires are contained within the gray jacketed, shielded cable.
Signal inputs (to SEQ), outputs (from SEQ) & signal ground are all
contained within the shielded cable. Function & connection of these
wires are as follows unless otherwise indicated on a tag attached to the
cable:
Green - Right Channel Input
(to SEQ from right channel output of source unit)
White - Left Channel Input
(to SEQ from left channel output of source unit)
Red - Right Channel Output
(from SEQ to right channel input of amplifier)
Black - Left Channel Output
(from SEQ to left channel input of amplifier)
Bare - Signal Ground
(from shielded cable to case of source unit)*
WIRES EXTERNAL TO SHIELDED CABLE:
Two wires are external to the gray jacketed, shielded cable.
Power Input & Power Ground connections are external to the shielded
cable. Function & connection of these wires are as follows:
Red - Power Input to SEQ
(connect to constant, ‘unswitched’, 12V source - fused)**
Black - Power Ground
(connect to case of source unit)*
4