9
Addressing Components on the DPN
The Digital Programming Network consists of 16 amplifier/DSP nodes
numbered 0 through 15. An extra node (number 16) can be occupied by the
in-dash controller (DRC-SL).
NOTE:
Turn all amps off before setting address switches
The binary numbering scheme is shown below with the DIP switch.
Settings for Each Node
When using the DRC-SL, leave all switches in the off position
except the Termination switch. Put Sw6 (Termination) to on. The DRC-SL
will then address to Node 16 (As Below)
Summary of Contents for DSP6-SL
Page 1: ......
Page 4: ...3 How a Balanced Signal System Works...
Page 16: ...15 At screen D click Next to go to Screen A and proceed as above...
Page 33: ......
