Monster LED User Manual
Zap Lighting – A brand of
3
S
AFETY
I
NFORMATION
Respect all locally applicable laws, codes and regulations when installing,
operating or servicing the fixture.
Protection from electric shock
Do not expose the fixture to rain or moisture.
Disconnect the fixture from AC power before carrying out any
installation or maintenance work and when the fixture is not in use.
Ensure that the fixture is electrically connected to ground
(earth).
Use only a source of AC power that complies with local
building and electrical codes and has both overload and
ground-fault (earth-fault) protection.
Socket outlets or external power switches used to supply the
fixture with power must be located near the fixture and easily
accessible so that the fixture can easily be disconnected from
power.
Isolate the fixture from power immediately if the power plug or
any seal, cover, cable, or other component is damaged,
defective, deformed, wet or showing signs of overheating. Do
not reapply power until repairs have been completed
Before using the fixture, check that all power distribution
equipment and cables are in perfect condition and rated for the
current requirements of all connected devices.
Use only Neutrik PowerCon cable connectors to connect to the
fixture’s power sockets.
Do not connect devices to power in a chain that will exceed
the electrical ratings of any cable or connector used in the
chain.
The supplied power input cable is rated 32 A and can safely
supply only one fixture with mains power.
If you replace this cable must also have three conductors
18 AWG or 0.75 mm² minimum conductor
size, have an outer cable diameter of 6 - 15 mm (0.2 - 0.6 in.)
and be temperature-rated to suit the application.
Protection from burns and fire
Do not use the fixture to illuminate surfaces within 1000 mm
of the fixture.
Operate the fixture with ambient temperature between
–5° C to + 45° C / 14° F to 113° F.
The surface of the product casing can reach up to 120° C
(248° F) during operation. Avoid contact by persons and
materials. Allow the fixture to cool for at least 15 minutes
WARNING!
Read the safety precautions in this manual before
Installing, powering, operating or servicing this product.