Zanussi ZWT80700W, User Manual

Page: 13 / 32

5. Restore it and adjust
the convex place to align
at the pump hole.
6. Tighten the pump cover
clockwise.
WARNING! • Make sure that valve
cap and emergency drain hose are
reinstalled properly, cap plates should
be inserted aligning to hole plates
otherwise water may leak.
• Some machines don’t have
emergency drain hose, so step 2 and
step 3 can be skipped. Rotate lower
cover cap directly to make water run
into basin.
• When the appliance is in use and
depending on the programme selected
there can be hot water in the pump.
Never remove the pump cover during a
wash cycle, always wait until the
appliance has finished the cycle, and
is empty. When replacing the cover,
ensure it is securely re-tightened.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
MAINTENANCE & POSSIBLE FAILURE
WARNING! Refer to Safety chapters
The start of the appliance does not work or it stops
during operation.
First try to find a solution to the problem, If not,
contact the service centre.
Problems with alarm messages
Display
Error
Reason Solution
E1 Alarm for abnormal water intaking. Check the water tap is opened or not.
E2 Alarm for water drain has not finished. Check the water level sensor and drain
pump.
E3 Alarm for lid not closed before wash and
spin.
Closed the lid.
E4 Alarm for washing stay at one side. Manually balance clothes in the barrel by
hands.
EXX Others. Please try again first, call up service line if
there are still troubles.
13