Zanussi ZWG6120 P, User Manual

Page: 6 / 68

6
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
Using a spanner,
unscrew and
remove the two rear
bottom screws.
With the machine laid on it’s back, place the
Slide out the two
plastic pins.
Lay the machine on its back ensuring that
the hoses are not crushed.
Place one of the
polystyrene angle
packings under
the machine.
Slide out the
relevant pin. Cover
all the open holes
with plugs which
are provided with
the Instruction
booklet.
Set the machine upright and unscrew the
remaining rear screw.
Remove the
polystyrene block(s)
protecting the
motor
bottom cover as marked in position A, Then
push the other end of the cover as directed
Very carefully slide
out the polyethylene
bag, removing it
towards the
downwards, then
pull it out.
(If any)
to close the bottom
of washing machine
(This is available
in selected
models only).
Important!
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or cupboard units.