Zanussi ZWF142E3PW, User Manual, Page: 19 / 32

With the flap in the position DOWN:
• Do not use gelatinous or thick liquid
detergents.
• Do not exceed to liquid detergent dose
indicated on the flap.
• Do not set the prewash phase.
• Do not set the delay start function.
5. Measure out the detergent and the fabric
conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause a blockage
when you close the drawer.
SETTING A PROGRAMME
1. Turn the programme dial to select the desired
washing programme.
The indicator of the Start/Pause button flashes.
The display shows an indicative programme
duration.
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons. The related indicators
illuminate on the display and the given
information changes accordingly.
If a selection is not possible an
acoustic signal sounds and the display
shows
.
STARTING A PROGRAMME
Touch the Start/Pause button to start the
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. programme dial on a wrong
position).
The related indicator stops flashing and stays on.
The programme starts, the door is locked. The
display shows the indicator
.
The drain pump can operate shortly
before the appliance fills water.
STARTING A PROGRAMME WITH THE
DELAY START
1. Touch the Delay Start button repeatedly until
the display shows the desired delay time. On
the display the indicator shows
.
2. Touch the Start/Pause button. The
appliance door locks and starts the countdown
of the delay start. The display shows the
indicator
.
When the countdown is completed, the programme
starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to pause the
appliance. The related indicator flashes.
2. Touch the Delay Start button repeatedly until
the display shows and the indicator goes
off.
3. Touch the Start/Pause button again to start
the programme immediately.
Changing the delay start after the countdown
has started
To change the delay start:
1. Touch the Start/Pause button to pause the
appliance. The related indicator flashes.
2. Touch the Delay Start button repeatedly until
the display shows the desired delay time.
3. Touch the Start/Pause button again to start
the new countdown.
THE AUTOADJUST SYSTEM LOAD
DETECTION
After touching the Start/Pause button:
1. The AutoAdjust System starts estimating the
weight of the load to calculate the real
19