FIXING PLATE KIT
If you install the appliance on a plinth that is not an
accessory supplied by ZANUSSI, secure the
appliance in the fixing plates.
Read carefully the instructions supplied with the
accessory.
TECHNICAL DATA
Dimension
Width/ Height/ Total depth
59,7 cm /84,7 cm /65,7 cm
Electrical connection
Voltage
Overall power
Fuse
Frequency
230-240 V
2200 W
13 A
50 Hz
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture
IPX4
Water supply pressure
1)
Minimum
Maximum
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Water supply
2)
Cold water
Maximum Load
Cotton
10 kg
Spin Speed
Maximum spin speed
1351 rpm
1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your do-
mestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the bottom of the water storage tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.
INSTALLATION
WARNING! Refer to Safety chapters.
UNPACKING
1. Open the door. Remove all the items from the
drum.
Accessories delivered with the
appliance may vary depending on
the model.
2. Put the packaging element on the floor behind
the appliance and carefully put it down onto its
rear side. Remove the polystyrene protection
from the bottom.
1
2
CAUTION! Do not lay washing
machine on its front.
6
