Zanussi ZWD 71463 NW, User Manual

Page: 16 / 28

• The door lock indicator is on. The indicator
flashes. The door stays locked.
• You must drain the water to open the door.
To drain the water:
1. If necessary, decrease the spin speed. If you
set , the appliance only drains.
2. Press . The appliance drains the water and
spins.
3. Turn the programme knob to position to
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
STAND-BY
Some minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates.
The energy saving status decreases the energy
consumption when the appliance is on the stand
by.
• All indicators and the display go off.
• The indicator of the
flashes slowly
• Press one of the options to deactivate the
energy saving status.
If you set a programme or an option
that ends with water in the drum, the
energy saving status function doesn't
activate to remind you to drain the
water.
DAILY USE - DRYING ONLY
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
DRYING SETTING
WARNING! Make sure that the
water tap is open.
1. Turn the programme knob to to activate the
appliance.
2. Load the laundry one item at a time.
3. Turn the programme dial to the programme
applicable for the items to dry. The display
shows the drying indicator .
To have a good drying performance
do not exceed the maximum drying
loads recommended in the user
manual. Do not set a spin speed
lower than the automatic speed of the
set programme.
DRYING AT AUTOMATIC LEVELS
The laundry can be dried at pre-defined levels of
dryness:
1. Press again and again until the display
shows one of the dryness level indicator:
• : IRON DRY level indicator for cotton
items
• : CUPBOARD DRY level indicator for
cotton and synthetic items
• : EXTRA DRY level indicator for cotton
items
The display shows a time value, calculated on the
default load size. If the amount of your laundry is
more or less than the default size, the appliance
adjusts automatically the time value during the
cycle.
2. Press
to start the programme.
The display shows the door locked indicator .
The drying indicator starts to flash.
You cannot set all dryness levels for
any type of laundry.
TIMED DRYING
The laundry can also be dried with a manual timed
drying:
1. Press
again and again to set the time value
(see the «Programmes for timed drying» table).
16